PRELIMINARY
FCC 11/30
MDE-3883 TRIND Retrofit Kits C00011-005
• 10/00
Page 1
Introduction
Purpose of this Manual
This manual provides instruction for installing TRIND™ Retrofit Kits C00011-
005-XX in The Advantage
®
Series wide frame and narrow frame units and MPD
®
3
units with InfoScreen
®
, monochrome CRIND
®
, or single-line CRIND.
The TRIND option allows customers to automatically authorize CRIND-equipped
units using a hand-held transponder tag provided by a major oil company (MOC).
Use these kits for one- or two-sided units.
Prerequisites
Before installing the TRIND kit, ensure that the existing CRIND has the Z-180
logic board T17764-XX, which is not provided in TRIND retrofit kit.
Important Notice
This equipment has been tested and found to comply with the limits for a Class A
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses and
can radiate radio frequency energy, and if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense. Changes or modifications not expressly approved
by the manufacturer could void the user’s authority to operate this equipment.
Required Reading
Before installing the equipment, the installer must read, understand, and follow:
• this manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• applicable federal, state and local codes and regulations
Failure to do so may adversely effect the safe use and operation of the equipment.
Note: This kit must be installed by a Gilbarco ASC (Authorized Service Contractor)
to insure warranty.
MDE-3883
TRIND™
Transmitter/Receiver in Dispenser
Retrofit Kits C00011-005-XX
Installation
