1900052
REV.6
Page 2
SAFETY:
This appliance must be earthed. If the moulded plug supplied is not used then ensure that
the green/yellow cable is connected to a suitable earth.
Risk of flooding. The hose supplied with this unit is non-toxic food quality tested to 190psi.
However, a hose is not a permanent connection. It is, therefore, advisable to switch off
boiler and close the stopcock valve when boiler is not in use, e.g. overnight, weekends etc.
Risk of scalding.
The utmost care has been taken in the manufacture and testing of this unit. Failure to
install, maintain and / or operate this boiler accord
ing to the manufacturer’s instructions
may result in conditions that can cause injury or damage to property. If in any doubt about
the serviceability of the boiler always contact the manufacturer or your own supplier for
advice.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance
In the event any wires are damaged, such wires can only be replaced by experts or
professional after service staff from the manufacturer, after service department or similar
function departments
INSTALLATION DETAILS:
Electrical installation:
When installing the product, always observe the local regulations and standards.
Products without an electrical plug are to be connected by an authorised professional installer.
Power
supply (V)
2.4kW version
Power Ratings
2.8kW Versions
Power Ratings
5.6kW Versions
Power Ratings
220
2.2kW
2.6kW
5.2kW
230
2.4kW
2.8kW
5.6kW
240
2.6kW
3.0kW
6.0kW
Plumbing insta llation proce dure:
Mains water pressure required (limits): 5-50psi (35-345kPa)
Fit a stop Valve on a cold water line and attach a 3/4" BSP male fitting,
(e.g. 3/4" x 1/2" 311 or washing machine type stop valve).
For US versions use 3/8” NPT male fitting
Connect straight tailpiece of the hose to the stop valve fitting. Make sure that the pre-attached
sealing washer is fitted.
Turn on the water to flush any impurities, dust etc from the inlet hose and water pipe. Allow
several gallons through.
Connect right-angled tailpiece of the hose to the inlet valve of the boiler (again 3/4" BSP).
Make sure the sealing washer is fitted here also.
Turn on water and check for leaks.
If the overflow vent is plumbed it must be plumbed with a tundish device.
This equipment must be installed with adequate backflow protection to comply with all
applicable federal, state and local codes.
Operating boiler for the firs t time:
Check that all installation procedures have been carried out.
Ensure water valve is on.
Plug boiler appropriate electrical supply and press power button on the front of the machine
marked ‘Power’. Refer to Figure 1.
