Fig. 13. Install alternator fan (221-A) and pulley (206-A)
over the alternator shaft. Use the lockwasher (S685) and
then tighten pulley nut (impact to 90 ft, pounds). Install
Alt Cap (306-A) with (3) 8-32 x 1" SHCS (S028).
Fig. 14. Push the Alternator and A/C inward to their
fullest position and Install a 64" belt belt.
Check and tighten all bracket bolts and alternator and Power Steering lower mounting bolts, turn engine over once
by hand to check for any belt rubbing and proper belt alignment. Run engine three minutes and check belt tension
again.
Fig. 15. Slip the supplied March Adjustment tool
(21206) over the two (MM100) bushings. Use a wrench
to turn the adjustment tool outward to tighten the
serpentine belt to 100 ft. lbs. Use the holes in the
adjustment tool to tighten both M8 socket head cap
screws when correct belt tension has been achieved.
Remove the adjustment tool and keep for future use.
11.
12.
13.
14.
15.
Fig. 11. Apply Loc-Tite to the threads of the (4)
5
⁄
16
-24 x
5
⁄
8
" SHCS (S183). Install adaptor ring (S716). Place water
pump pulley (6302-A or 6307-A) to the water pump
and thread the cap screws through pulley and into water
pump pulley flange, tighten firmly (28 ft/lbs.)
Final Assembly
Fig 12. Apply Loc-Tite to the threads of the (3)
3
⁄
8
-16
x 1" SHCS (S248). Place the crank pulley (7661-A) on
damper and align holes. Thread the (3) screws through
pulley and into damper, tighten firmly (50 ft/lbs.)
