• Disconnect the battery to prevent accidental engage-
ment of starter motor.
• Drain coolant from system
• If your A/C is intact and charged it must be evacuated.
This is best done by a professional garage with proper
recycling equipment
• Remove the existing alternator, air conditioning com-
pressor and associated brackets.
• Remove all pulleys and water pump.
Preparing to Install
Installing the Kit
1.
2.
3.
• Remove all traces of old gasket and sealer with gasket
scraper and steel wool pad.
• Clean threads in block by chasing with appropriate
thread chasers.
NOTE: : If using old style cylinder heads that have freeze
plugs contact tech support before install.Support brack-
ets will have to be modified or modifications to freeze
plugs will need to be made.
3
⁄
8
" x 3" studs and
Paper Gaskets
Fig 1. Ensure the sealing face of the coolant outlets are
clean, flat and free of old gasket material. Apply a small
amount of RTV silicone to one end of each mounting
stud to prevent coolant seepage. Install the (4)
3
⁄
8
x
3" mounting studs (S339) into the four water pump
mounting holes
1
⁄
2
" inch deep into block.
Fig 2. Install (2) Paper Gasket (S676) over the studs
and the on the passenger side install the Alternator Rear
Support Bracket (21263-A). On the drivers side install
the Power Steering Rear Support Bracket Drivers Side
(21262-A)
Fig 3. Install the second set of Paper Gaskets over the
studs and slide the Water pump (P-125) over the four
studs.
Fig. 4. Install (4) Stainless Spacer (S785) onto the studs .
4.
