Marathon Technologies Corporation
31
On the
Endurance Network Setup
page make sure that the desired
adapter is still highlighted and select
Use currently configured IP
addressing
. Click Next to continue.
5.
If your network configuration will not use CoServer Link 2
,
select
No
Coserver Link 2
and then click
Next
without selecting an adapter.
If you will be using CoServer Link 2, then on the
Configure CoServer
Link2
page, highlight the adapter you wish to assign as CoServer Link2
in the
Connection
column. Select the adapter based upon the PCI loca-
tion-to-switchbay mapping you established during planning and prepara-
tion.
Right click on the selection and choose
Internet Protocol Properties
from the action menu. On the
Internet Protocol Properties
page select
Use the following IP address,
fill-in the appropriate address
,
enter
Subnet mask
255.255.255.0 and click OK.
On the
Endurance Network Setup
page make sure that the desired
adapter is still highlighted and select
Use currently configured IP
addressing
. Click Next to continue.
6.
If your network will not use a CoServer Management connection, push
Next
without highlighting an adapter
If you will be using CoServer Management, then on the
Configure CoS-
erver Management
page, highlight the adapter you wish to assign for
CoServer Management in the
Connection
column. Select the adapter
based upon the PCI location-to-switchbay mapping you established dur-
ing planning and preparation.
If you wish to assign an IP address, right click on the selection and
choose
Internet Protocol Properties
from the action menu. On the
Internet Protocol Properties
page select
Use the following IP
address,
fill-in the appropriate address,
enter the desired Subnet mask
and click OK. Click Next to continue.
7.
On the
Endurance Network Setup
page if the
Update Network Con-
nections adapter names
box is checked, when you restart the system
Network Setup will reassign the adapter names. Click Apply.
8.
Click
Exit
.
