Installing the Endurance Software
30
Marathon Technologies Corporation
1.
Browse the CD and double-click
setup.exe
.
2.
From the
Installation Launcher
, select
Install CoServer
. Follow the
prompts as you did during CoServer 1 installation to set the license num-
ber, select features, choose CoServer 2 install, and define the installa-
tion location. When the Endurance Network wizard runs proceed to step
3 below.
3.
On the
Configure Redirected
page, enter 1 in the
Specify total num-
ber of Redirected adapters
, and highlight the adapter you wish to
assign as Redirected in the
Connection
column. Select the adapter
based upon the PCI location-to-switchbay mapping you established dur-
ing planning and preparation.
4.
On the
Configure CoServer Link1
page, highlight the adapter you wish
to assign as CoServer Link1 in the
Connection
column. Select the
adapter based upon the PCI location-to-switchbay mapping you estab-
lished during planning and preparation. You can use Table 2 to assign IP
addresses for internal CLink connections.
Note:
When installing multiple blade pairs, the first blade pair has the
same IP for both the default IP and the currently configured IP.
This will not be the case for subsequent blade pairs.
Right click on the adapter selection and choose
Internet Protocol Prop-
erties
from the action menu. On the
Internet Protocol Properties
page
select
Use the following IP address
and fill-in the appropriate address
.
Then, enter
Subnet mask
255.255.255.0 and click OK.
TABLE 2.
Suggested CoServer2 CLink IP Address
Blade Pair 1
Blade Pair 2
Blade Pair 3
CoServer1
CoServer2
CoServer1
CoServer2
CoServer1
CoServer2
CSLink1
192.168.3.1
192.168.3.2
192.168.13.1
192.168.13.2
192.168.23.1
192.168.23.2
CSLink2
192.168.4.1
192.168.4.2
192.168.14.1
192.168.14.2
192.168.24.1
192.168.24.2
