Marathon Technologies Corporation
25
On the
Endurance Network Setup
page make sure that the desired
adapter is still highlighted and select
Use currently configured IP
addressing
. Click Next to continue.
3.
If your network configuration will not use CoServer Link 2
,
select
No
Coserver Link 2
and then click
Next
without selecting an adapter.
If you will be using CoServer Link 2, then on the
Configure CoServer
Link2
page, highlight the adapter you wish to assign as CoServer Link2
in the
Connection
column. Select the adapter based upon the PCI loca-
tion-to-switchbay mapping you established during planning and prepara-
tion. You can use Table 1 to assign IP addresses for internal CLink
connections.
Right click on the adapter selection and choose
Internet Protocol Prop-
erties
from the action menu. On the
Internet Protocol Properties
page
select
Use the following IP address
and fill-in the appropriate address
.
Then, enter
Subnet mask
255.255.255.0 and click OK.
On the
Endurance Network Setup
page make sure that the desired
adapter is still highlighted and select
Use currently configured IP
addressing
. Click Next to continue.
