ENGLISH
9
CLONE MODE
Creating copies using clone mode
All of the codes programmed to the RC101 remote
controller can be copied to another RC101 using a
few simple operations.
• The remote controller can copy the entire
contents.
• When copying the entire contents, all programmed
codes are copied.
Note:
The clone function can only be used for copying
when using the same model (RC101) for both the
transmitting and receiving remote controller.
Copying entire contents
1.
Place the receiver sensor of the receiving
remote controller (top) so that it is facing the
transmitter of the transmitting remote controller
(top) at a distance of about 2 inches (5 cm).
2 inches
SYS
TE
M R
EMO
TE C
ONT
ROL
LER
SY
ST
EM
R
EM
OT
E C
ON
TR
OL
LE
R
2.
Press
SET
button and
PLAY
button of the
transmitting remote controller until the SEND
indicator blinks twice.
Then backlight fl ushes
The transmitting side is now ready.
3.
Press
SET
button and
STOP
button of the
receiving remote controller until the LEARN
indicator blinks twice.
Then backlight fl ushes.
The receiving side is now ready.
4.
Press
the
ENTER
cursor button on the receiving
remote controller.
Then back lights tune off.
5.
Press
the
ENTER
cursor button on the
transmitting remote controller.
Then backlights tune off.
6.
When copying is started, the SEND indicator of
transmitting remote controller and the LEARN
indicator of receiving remote controller start to
blink.
When the copying operation is completed, the
back lights of transmitting remote controller and
receiving remote controller are turned on.
Do not touch either of the remote controls
during the copying operation. Doing so could
cause copying to fail.
If the copying fails in the middle of the copying
process, back light of receiving remote are
flush. Press the
SET
button to return the
normal mode. Check and perform steps 1 to 5
again.
Copying takes about 30 seconds to complete
when the transmitting remote controller has
been programmed to 100% capacity.
7.
Once copying is completed, press the
SET
button on both remote controls.
OTHER OPERATIONS
CHANGE THE MULTI ROOM CONTROL COMMANDS
FOR EACH ZONE
(When operating Marantz AV Receiver by Multi Zone
connected)
• Zone A: Multi room A control (Default)
• Zone B: Multi room B control
• Zone C: Multi room C control
• Zone D: Main room control
Change the control commands for each zone.
2.
1.
1.
Press
SET
button and
ZONE
button until the
SEND indicator blinks twice.
Then backlight fl ushes.
2.
Press each zone button(A/B/C/D button)
When the procedure is successful, the SEND
indicator will blink twice.
These buttons change a special code of each zone.
POWER ON/OFF
SOURCE
INFO
VOL +/–
SLEEP
MUTE
Tuner mode operation remote code (Refer to p.5)
CHANGE THE CONTROL COMMANDS OF MULTI
SPEAKER FUNCTION FROM MULTI ROOM.
1.
2.
1.
3.
1.
Press
SET
button and
POWER ON
button until
the SEND indicator blinks twice.
Then backlight fl ushes.
2.
Press the 1-digit code by numeric keys.
• Multi room mode: 1 (Default)
• Multi speaker mode: 2
Note
In case of Zone D, only control for main room is
possible.
3.
Press
ENTER
button once to lock in the code.
When the procedure is successful, the SEND
indicator will blink twice.
These buttons change a special code of multi room
mode or multi speaker mode.
Note
The control commands can be set independently in
ZONE A/B/C.
POWER ON/OFF
VOL +/–
MUTE
