28
PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC.
The procedure after replacing the u-COM (microprocessor), flash ROM, etc. is as follows.
PCB Name Ref. No.
Description
Procedure after
Replacement
備考
MAIN
IC11
R5F56108VNFP
B
Main
MAIN
IC24
H27U1G8F2BTR-BC
B
Network
MAIN
IC32
MX25L4006EM1I-12G
B
USB
Procedure after Replacement
A :
The software has been written. The software is not written at the time of replacement.
B :
The software has been written. The software may need to be rewritten by version updates. Check the version.
C :
The software has not been written. The software needs to be written after replacement.
See "
Firmware Update Procedure
" for information on writing the software.
D :
The software has been written. Be sure to rewrite with the latest software for your service region.
See "
Firmware Update Procedure
" for information on writing the software.
Summary of Contents for NA8005
