From the Utilities Window, can be accessed also the all processes for Saving/Recalling presets
to/from Pc and to/From the DPA880 and for configuring Special Processes activated by the
External Switch Input Ports.
Particularly:
Load
: allows to load on the Pc Remote Control a configuration previously saved on Pc
Save
: allows to save on Pc the current editing session
Store
: allows to store on the DPA880, in one of the 6 available location, the current editing
session
Read
: allows to read from the DPA880, one of the 6 stored presets and to display it on the
current editing session
Input Copy
: allows to copy the setting of one Input channel on an other one
Output Copy
: allows to copy the setting of one Output channel on an other one
Switch
: this particular button is allowing to enter e window where from up 4 lines (switches) can
be set as 0 (boxes unchecked) or 5V (boxes checked).
The switched controlled by this window actually set as 0V or 5V the physical 4 output “switch”
lines available on the DPA880 back panel and useful for controlling remote devices.
Stop
: allows to unconnect the currently edited unit from the PC Sw without exiting the Pc Sw
itself.
This function is useful when operating in net mode with more units connected all together.
Extra Program
: the External Program section is allowing the user to set as active or not active
anyone of the 4 available Input Switches.
When set as active one or more of them, it is also possible to define with the “Configure Mode”
option, if the Input Switch signal has to be considered active on its High or Low level detected.
