The power connector on the Silver Plus Series is a terminal block with wire clamps.
Lugs are not required.
Panel Prep a ra tion
A metal panel or mounting surface with a minimum thickness of 15 gauge (0.059
inch/3.3mm) if cold-rolled steel or hardened steel, or 10 gauge (0.101 inch/2.6mm) if
aluminum alloy (6061-T6 preferred) is required. Thinner panels or surfaces may bow
between the mounting clamps and not form a seal with the gasket.
The area of the panel or mounting surface where the gasket comes into contact must be flat
and free of scratches, pits, and other features that prevent the gasket from sealing properly. If
the panel or mounting surface is not uniform, thick, flat, stiff, or smooth enough, then a
sealant such as silicone may be required.
Warning:
The OIT requires a stiff, flat, smooth mounting surface free of blemishes to
seal properly to NEMA 4.
Clean and deburr the panel cutout before the OIT is installed.
9
Sil ver Plus Se ries
1010-1006, Rev 01
Power Con nec tor on OIT
