Con fig u ra tion Wir ing
The OIT must be configured for a particular protocol before use. The
EZware-5000
software is used for configuring the OIT. For detailed instructions on installing and using
the software, please refer to the software documentation section of this manual.
Con nect the OIT to the PC for Con fig u ra tion
To configure the OIT using Maple System’s configuration software, you will need an
Ethernet crossover cable, Maple P/N 7431-0102. If using a switch or router between the PC
and the OIT, use a straight-through or crossover cable as required by the switch or router.
If an Ethernet port is not available on the PC, you may be able to install a USB Ethernet
adapter. You can also transfer the project to the OIT with a Compact Flash or USB memory
device.
For More In for ma tion
For information on PLC connection, programming and operations of your Silver Plus Series
OIT, please see the
Silver Plus Series Installation and Operations Manual,
part number
1010-1007, which is available on our website at www.maplesystems.com or on the
EZware-5000 programming software CD.
11
Sil ver Plus Se ries
1010-1006, Rev 01
