1. Open the battery cover and insert the battery (normally a battery is
already installed).
3. Charging the battery by connecting the camera to a computer or
other USB charging adapter using the included USB cable. The camera
status light turns on during charging.
Note:
Using wall chargers marked: output 5V 1A. If you don’t know the
voltage and current of your charger, use the included USB cable to
charge the camera from your computer or a power bank.
Note:
The microSD card is sold separately. The microSD card must have
a Class-10 or UHS-I rating and the capacity up to 128GB
.
Inserting / Removing Memory Cards
To Insert the microSD Card:
To Remove the microSD Card:
Slide the memory card into the
card slot with the label facing
the back of the camera.
When fully inserted, the card
clicks into place.
Place your fingernail against the
edge of the memory card and
lightly press it further into the
camera.
The card springs out far enough
to be removed.
SD
SD
04
05
There are 4 LEDs on the camera, the default status is showed as below,
and also user can turn on or off LED in the menu.
Status LEDs
Status
The camera is powered on
and in standby mode
The camera is recording
In photo mode
A photo taken
Battery charging
Battery charging
completed
Firmware upgrading
LED Activity
/
/
/
/
/
/
/
/
/
Front LED 1
Front LED 2
Solid Green
Flashing Green
Once
Solid Red
Solid Red
Solid Red
Top LED
Solid Red
Solid Red
Flashing Green
Flashing Red Flashing Red
Flashing Red Flashing Red
Flashing Red
Flashing Red
Solid Red
Flashing Red
Solid Red
Solid Green
Solid Red
Back LED
Getting Started
Press to unlock the battery
cover, then push it out.
Rechargeable battery
Charging the Battery
Inserting / Removing the Battery
