Customer Support
1.800.897.9755 x1
MM710
Installation Instructions
16
{22}
{22}
17
Install 4 Screws {15} through the TV Brace {33}
and into the Vertical Braces {31}.
4.6
Insert the two Cable Tie Anchors {22} into the two
holes in the Lower Arm of the Lifting Mechanism. Press
firmly until they are flat.
Shown here is the easiest way to attach
cables. Use the included Cable Ties {24}
to attach cables so they are sideways to
the Lower Arm, making a gentle loop.
Cables should be long enough to
accommodate the extension and swivel
of MantelMount. Check all ranges of
motion before tightening the Cable Ties.
4.7
4.8
2 inches
MAX
4.9
Center the TV on the TV Frame and
check it with a level.
Carefully slide the TV sideways, if
required, until it is balanced and
horizontal, up to a MAXIMUM OF
2 INCHES left or right.
The TV would only need to be moved
off-center if it has an unbalanced weight.
These are usually older, heavier TVs.
If the TV needs to be moved sideways
and is visually too much off-center
above the mantel, remove the TV and
relocate the Wall Plate {32} an equal
distance but in the opposite direction
of the TV to compensate.
4.5
CL
Attach the electrical and signal
cables to the TV.
Give each segment of the cables extra
length so that they are not stressed or
kinked when the mount moves.
Ensure that cables do not get pinched
within the Lifting Arm when the TV is
raised.
Reference Only:
This is one possible
configuration for the signal cables. Each
segment of the cables has extra length
so that the cables are not stressed or
kinked when the mount is moved.
