MM710
Installation Instructions
15
14
Customer Support
1.800.897.9755 x1
STEP 4
Attach TV
to Mount
These Next Steps Will Require Two People.
Firmly pull down the TV Brace until the Lifting Mechanism
is in a horizontal position. DO NOT HIT THE MANTLE!
The second person must insert the Safety Bolt {20}
through the Safety Hole in the upper arm and install the
Safety Nut {21}. Slowly release the TV Brace. The Lifting
Mechanism should stay at a horizontal position.
4.1
NOTE: These Next Steps Will Require Two People
4.2
WARNING!
Do Not put hands into Lifting Mechanism without the
Safety Bolt and Safety Nut installed. The power of the
Lifting Mechanism can cause bodily injury!
4.3
25LB
50LB
75LB
100LB
Weight of TV
DO NOT
adjust all the way to the bottom. That
position is only to remove the Gas Springs.
Pre-set the lifting force.
Turn the main bolt CLOCKWISE (while looking
at the head of the bolt from underneath)
as shown to pull the Gas Springs DOWN for
heavy TVs. Rotate the bolt the other way for
less lifting force for lighter TVs.
See the diagram below for a Pre-Set estimate
for the Gas Springs. The lightest lifting force
is at the top, and the heaviest is down just
below the middle of the bolt threads.
This step requires two people.
Carefully hang the Television onto the
TV Brace making sure that all four hooks
on the Vertical Braces {31} engage the
TV Brace.
DO NOT allow the Television to drop far
enough to cause the Lifting Mechanism
{35} to hit the mantle.
MantelMount comes pre-adjusted to
reduce the possibility of contacting
the mantle, but you should always
be prepared to remove the television
at this stage to make the proper
correction.
If the Lifting Mechanism {35} appears
to be too close to the mantle, remove
television. Go to STEP 5.1 and make an
adjustment to the Bottom Stop position.
Repeat this process until the Lifting
Mechanism is a safe distance from the
mantle when the TV is installed.
4.4
