MM710
Installation Instructions
11
10
Customer Support
1.800.897.9755 x1
Attach the Wall Plate {32} using Lag Bolts {17} and
Washers {10} directly into the centers of the studs.
3.1
: Do Not overtighten Lag Bolts {17}. Tighten
only until the washers are firmly against the wall plate. Damage
due to overtightening can cause property damage or injury.
BEFORE
Wall plate impeded by outlet.
BEFORE
If the wall plate sits directly behind lifting
arm wall plate must be moved up.
After
Wall Plate lowered to clear outlet.
After
Wall plate moved up to clear outlet.
If necessary, move Wall Plates to clear an outlet.
If a Wall Plate installation is impeded by an electrical outlet (or other) and professionally relocating the outlet is
impossible, try one of these two options:
Move Wall Plates up or down to clear the outlet. As long as you don’t place the LOWER Wall Plate below the
Minimum Distance (Step 2.2) or above the Maximum Distance (step 2.3), MantelMount will still function properly.
Simply move the Wall Plates up or down enough to clear the outlet, leaving them as close as possible to the
originally planned vertical positions.
IMPORTANT:
You must now move the Vertical Braces {31} on the back of the TV using the same number of inches
used to move the Wall Plates (e.g., move the Vertical Braces down 2" if the Wall Plates were moved down by 2" ).
The bottom of the Vertical Braces must remain between 3 to 10 inches from the bottom of the TV.
Move the Wall Plates up enough to clear the outlet, leaving them as close as possible to the originally planned
vertical positions.
IMPORTANT:
You must now move the Vertical Braces {31} on the back of the TV using the same number of inches
used to move the Wall Plates (e.g., move the Vertical Braces up 2" if the Wall Plates were moved up by 2" ).
The bottom of the Vertical Braces must remain between 3 to 10 inches from the bottom of the TV.
NOTE: If outlet is directly behind the Lifting Arm, the only solution is to move the Wall Plates up.
STEP 3
Attach Mount
to Wall
Attach the TV Brace {33} to the lifting arm {35}. Level the
TV Brace and tighten the 4 screws {15}. NOTE: After TV is
mounted to bracket you may need to adjust these screws
to make final Post-Leveling adjustments (Step 5.4).
3.2
2.7
1
2
Insert top tabs of Lifting Mechanism {35} into the slots of
Wall Plate {32} then slide the bottom into position. Align
all four holes and install Screws {14}. Tighten Securely.
3.3
DO NOT
damage or scratch
the rods of the
Gas Springs!