• DOK-DIAX02-DDS02.1*ANA-ANW1-EN-E1,44 • 12.96
37
4. Commissioning equipment
4.3. Service cable IN 391
Fig. 31: Connecting up a personal computer via RS 232 interface to a DDS 2.1 with
ANALOG interface
4.4. Personal computer (PC)
Before connecting a PC or VT 100 terminal to the drive controller switch
off the power. INDRAMAT supplies special, pre-assembled cables, type
IN 391 to make the connection between the computer and the controller.
These are available in four different lengths. For more details, refer to Fig.
31.
The PC must fulfil the following conditions:
– IBM compatible
– MS-DOS operating system
– RS 232 interface installed
– Floppy disk drive or hard disk for storage of parameters
– VT 100 terminal emulation software installed
The VT 100 terminal emulation software (available from INDRAMAT)
allows you to display the user interface stored in the drive controller on
the PC’s monitor. To set parameters, follow the operating instructions for
the terminal emulation software.
ENA3A-Abb19/InbetrDDS
Signal
TxD
RxD
RTS
CTS
GND
Frame
Pin
2
3
4
5
7
Plug connector X2
Signal
TxD
RxD
RTS
CTS
GND
DTR
DSR
Pin
3
2
7
8
5
4
6
9-way D-type sub-miniature socket connector
Operating equipment
Terminal VT 100
or PC
RS 232 interface
DDS 2.1
X2
Available cable types IN 391 / 2
Lengths in m
(2, 5, 10, 15)
Service cable
