Section 3
Operation
Part Number 020003315
1/11
3-5
CONTROL BOX LABEL
The control box label is your programming reference
sheet and control board identifier. Becoming familiar with
this label will greatly assist you in programming, brixing
and even trouble shooting the boards on the Flav'R-Pic
unit if necessary. The illustration above tells you what
each area of the label does. In each called out area
there are abbreviated instructions for one of the three
programming modes.
MODE 1 = carb/non-carb & Flavor shot INFO
MODE 2 = Brixing
MODE 3 = Touch pad LED Sequencing
a program button is located just to the right of each
numbered LED display. The one on the left controls the
left control board and the one on the right controls the
right control board. Holding either in for approximately 3
seconds will put the respective board into a
programming mode. (See the Programming section for
programming mode details.) For this label to make
sense, especially when brixing, you will need to
reference the plumbing label located on the foam front
behind the splash panel and/or in the plumbing section
of this manual. It is recommended to only program one
board at a time.
Also located around the top and bottom edges on the
control box label are the locations of the wire harnesses
that are connected to the boards behind the box and the
valve or touch pad connection they plug into.
Operation Checks and Adjustments
FRP-250 (NON-ICE CRUSHING UNIT) ICE DELIVERY
SWITCH ADJUSTMENT
To properly adjust the switch, first unplug the power cord
to the unit then remove the merchandiser. This will give
you access to the ice delivery switch located on the left
side of the rocking chute.
Begin by observing the chute by slowly pushing against
the rocking chute. When the ice delivery switch clicks,
measure the distance from the door stops on the rocking
chute bracket to the door. The distance between the two
must be no more than 1/4” (0.64 cm), but no less than
1/16” (0.16 cm).
The left side of the rocking chute has a tab that pushes
up on the ice delivery switch. To adjust it, use needle
nose pliers and bend the arm of the switch up or down in
order to change the point where the tab makes contact
with the switch arm.
0
0
Brixing
Info
Mode 1 Carb/
non-Carb &
Flavor Shot
Durations
Right Side
Program
Button
Left Side
Program
Button
Door
Door Lock
Door
Ice
Delivery
Door Stops
Door
Door Lock
1/16”
to
1/4”
Tab
Switch Arm
