Operation
Section 3
3-2
Part Number 020003315
1/11
Component Identification
Sequence of Operation
ICE RECOMMENDED FOR DISPENSING
Dispensers are designed to dispense hard, cube ice up
to one-inch square. The ice shapes and sizes listed
above are recommended for dispensing. Warm “Super
Cooled” Ice Before Dispensing: “Super Cooled” ice is not
recommended for dispensing. “Super cooled” ice is ice
that has been stored in freezers below 32°F. Should it be
necessary to temporarily use “super cooled” ice, allow
the ice to warm at room temperature for 25 to 30
minutes before placing the ice in the dispenser.
Flake or “nugget” ice is NOT to be dispensed from the
Flav'R-Pic. The Flav'R-Pic comes equipped with the
selectable ice feature so you are able to choose
between cubed or crushed ice making the addition of a
flake/nugget icemaker unnecessary.
ICE STORAGE AND DISPENSING
As the customer presses the rocking chute, the arm at
the top left rear of the chute pushes upward on the door
lock. The door opens until it contacts the stops in the
mounting brackets. The plastic arm on the ice chute also
activates the lever of the ice dispensing switch. When
activated, the micro switch starts the gear motor. The
gear motor turns the paddle wheel and agitator arm.
The paddlewheel carries ice. Periodic agitation is
standard on the 30" and larger dispensers. During
periodic agitation, the paddle wheel and agitator turn for
approximately three seconds every three and one half-
hours. The door lock prevents ice from being dispensed
during the agitation cycle.
BEVERAGE VALVES
Post-mix beverage valves are designed to precisely
meter the flow of both water and syrup to obtain the
proper mixing ratio. The syrup and soda water
components of the post-mix beverage are mixed as they
leave the beverage valve.
Merchandiser
Nozzles
Key Switch
Drainpan Grid
Drainpan
Splash Panel
Lower Merchandiser
& Beverage Selection
Touch Pads
Nozzles
Selectable Ice
Touch Pad
Ice Chute
ADA Touch Pads
(on units with this feature)
ADA Touch Pads
(on units with this feature)
Half Dice
3/8" x 1-1/8" x 7/8"
(1.0 x 2.9 x 2.2 cm)
Half Dice
3/8" x 1-1/8" x 7/8"
(1.0 x 2.9 x 2.2 cm)
