Manitou 260 TJ, Instruction Manual

Page: 117 / 138

3-23
C11 - TIGHTNESS OF THE AXLE FIXING BOLTS ON THE CHASSIS
CHECK
- The tightness of these bolts must be checked, at the latest, after 50 hours of operation. This check must then be repeated after every 250
hours of operation.
- The bolts’ tightening torque is 28 daN.m ± 10 %.
- 1 daN = 1 Kg.
C12 - ARM POSITION SENSORS
CHECK
For this operation, fold the arms into transport position.
- Make a translation movement at transport speed
- Raise the arm and the telescope or extend the telescope
- Move forward
- The platform should switch to Work speed.
If a malfunction occurs, prohibit use of the platform. Contact your dealer.
C13 - TILT SENSOR
CHECK
For this operation, unfold the arms.
- Set the platform in a position where the tilt is greater than the permissible level (see: 2 – DESCRIPTION: SPECIFICATIONS).
- The movements for extending the telescope and raising the arms should be blocked (the tilt light is lit in the basket; the buzzer is
activated intermittently in the basket).
If a malfunction occurs, prohibit use of the platform. Contact your dealer.
C14 - OVERLOAD SENSORS
CHECK
For this operation, fold the arms into transport position.
- Place a weight larger than that indicated in the basket (see: 2 - DESCRIPTION: SPECIFICATIONS).
- The movements for extending the telescope and raising the arms should be blocked (the overload light is lit in the basket; the buzzer is
activated continuously in the basket).
If a malfunction occurs, prohibit use of the platform. Contact your dealer.
C15 - COOLANT CIRCUIT HOSES
CHECK
If the coolant circuit hoses are damaged or the coolant is leaking, this may cause overheating or severe burns.
- Open the bonnet.
- Visually check the condition of the cooling circuit hoses and the tightening collars. If these are blistered, hardened or cracked, replace
them immediately.
(Contact your dealer)
647382 EN (01/02/2015)