25
The plough share is bolted to a bracket that is
mounted on the mouldboard. This bracket has two
holes (A)
–
for shallow and deep ploughing. There
are two longitudinal holes in the bracket to be
adjusted according to conditions.
The front edge of the optimally set plough share
should be positioned at the mouldboard, and the
rear edge should be adjusted according to the
ploughing depth.
4.11.
ORKAN and ORKAN VARIO skimmer
Fig. 13 Construction of the skimmer.
The skimmer set consists of a support bolted to the plough body holder. It supports the
skimmer standard to which the working components are bolted
–
the plough share and
mouldboard. The working depth of the skimmer is set using the holes of the bracket by
turning the bolts holding the standard. The lower bolt securing the components against
overload has a circumferential groove that allows the bolt to be shorn. The shear bolt
should always be mounted as shown in the figure above. The distance of the plough
share
from the share point is set in two positions: 0 mm and 70 mm. This is set by turning the
skimmer support 180°.
4.10.
Plough share
A holes
Skimmer support
Skimmer standard
Screw
Shear bolt
Mouldboard
Plough share
B holes
