20
4.5.
Adjustment of the ploughing width
4.5.1
ORKAN and ORKAN RESOR plough
To change the working width of the ORKAN plough, first, change the angle of the bodies
to the frame bar. To this end:
•
unscrew the M20 and remove the bolt from the hole,
•
adjust the body so that the corresponding holes overlap,
•
insert the bolt into the hole and tighten the nuts with a torque of 468 Nm.
Five working widths are available: 30 cm, 35 cm, 40 cm, 45 cm, 50 cm.
Fig. 9 Holes regulating the width of the implement.
Then, adjust the angle of the frame bar to the suspension so as to the body landsides are
parallel
to the direction of travel. This is done with the external fastener screw between
the head and the frame beam. To this end:
•
loosen the lock nut with a 46 wrench,
•
then use a 46 wrench to set the appropriate angle of the frame,
•
counter with a nut.
