11
4.2
Installation
4.2.1
Chain Hoist
Before pulling the hand chain through the pocket wheel, pull the limit
cam's retaining bracket back. Turn the cams to the center of the limit
shaft to be sure that they are not being mechanically driven through
their normal limit switch end positions.
1. Run the hand chain through the pocket wheel and through
the chain guide, see Figure 10.
2. Allow both ends of the chain to hang down toward the
ground until both ends are approximately 2 feet (0.6 m) from
the floor. Cut the hand chain if necessary.
3. Connect both ends of the hand chain together.
4.2.2
Disconnect Chain
1. Link the disconnect chain to the hook located at the
extremity of the operator's disconnect mechanism, see
Figure 11.
2. Install the handle under the chain keeper to facilitate
handling of the chain.
3. Under the handle, make a knot in order to fasten the end of
the chain.
For technical support, please call
1-800-361-2260
for more information
Figure 11 - Disconnect Chain
Handle
Disconnect
Mechanism from
Operator
Disconnect Chain
Knot
Figure 10 - Hand Chain Installation
Chain Keeper