Chapter 1
Introduction and accessory range
Page 1-2
MAN 0487
1
Cells and Cuvettes
Zeta potential measurements
Size and molecular weight measurements
DTS1070
Folded capillary cell
Maintenance-free capillary cell primarily designed for zeta potential
measurements. (This cell is a direct replacement for DTS1060/61).
ZEN1002
Dip cell
Cell used to provide repeatable measurements of aqueous, and
non-aqueous samples. It is particularly suitable for measurements
of valuable aqueous samples where minimal sample quantity is
important.
Use with DTS0012 and PCS1115 cuvette - described below.
ZEN1010
High concentration cell
Cell intended primarily for the measurement of zeta potential on a
concentrated aqueous sample. The cell is suitable for a broad range
of conductivities. It is particularly suitable for measurements of valu-
able aqueous samples where minimal sample quantity is important.
ZEN1020
Surface zeta potential cell
Cell intended for the measurement of the zeta-potential at the sur-
face of a flat material in an aqueous environment.
Use with DTS0012 and PCS1115 cuvette - described below.
DTS1070
Folded capillary cell
- This cell can be used for size measure-
ments, in the Zetasizer Nano S, Nano ZS and Nano ZSP only.
(This cell is a direct replacement for DTS1060/61).
DTS0012
Square polystyrene cuvettes - for size and molecular weight meas-
urements.
ZEN0118
Disposable polystyrene low volume cuvette - for size and molecular
weight (90° instruments only).
ZEN0040
Disposable plastic, micro cuvette, for size measurement at a 173°
scattering angle.
PCS8501
Square glass cell with cap (round aperture) - for size and molecular
weight. Also for use with the Dip cell.
PCS1115
Square glass cell with cap (square aperture) - for size and molecular
weight. Also for use with the Dip cell.
ZEN2112
Low-volume quartz batch cuvette - for size and molecular weight.
ZEN0023
Quartz flow cell - for size, intensity measurements and molecular
weight.
Note: All cuvettes have an outside dimension (o.d.) of 12mm
