Malvern Instruments Mastersizer X, Manual

Page: 32 / 102

.
Similarly, connect the sample return
Ã
to the outlet
Ä
on the Mastersizer
with sample tubing, via the associated hole in the front of the drawer
Å
.
.
Attach the Dispersion Unit cable on the Dispersion Unit
Æ
to the 15 way
D type connector on the Controller Unit.
.
Connect the mains power cable into the power socket at the rear of the
Controller Unit.
Power up the Accessory
Before powering up your Accessory, read chapter 2 - Health and Safety, in this
manual.
$
To power up your Accessory:
.
Check the on/off (1/0) switch
À
at the rear of the Controller Unit is in the
off (0) position and that the front panel speed control
Á
is fully anti clock-
wise, refer to the illustration below.
.
Check that the motor connector
Â
to the rear of the Controller Unit is
connected.
.
Connect the mains power plug into the mains supply and switch on.
.
Switch the on/off (1/0) switch
À
at the rear of the Controller Unit to the
on (1) position.
Dispersion
Unit Controller
I N S T R
U M E N T
S
Dispersion
Unit Controller
I N S T R
U M E N T
S
Stirrer
Speed
RPM
Small
Volume
Sampl
e Dispersion
Unit
I N
S
T R
U M
E N
T S
Small
Volume
Sampl
e Dispersion
Unit
I N
S T
R U
M
E N
T S
7
4
1
ILL
3043
C H A P T E R 3
Q S S m a l l V o l u m e S a m p l e D i s p e r s i o n U n i t
P a g e 3 . 8
M A N 0 1 6 1