Malsch IMPULSE KL, Instruction Manual

Page: 43 / 64

| 43
IMPULSE KL hospital bed
with undercarriage Editions 300-P / 400-P
1. Adjustable lower leg support (notched bracket)
2. Mattress holder
3. Adjustable upper leg support
4. Static seat panel
5. Adjustable back rest
6. Potential equalisation (external)
7. Trapeze bar mount (external)
8. Head board
9. Mounting brackets for accessories
(4 x surrounding the bed)
10. Recess for retrofitting a side rail
11. Wall bumper (4 x surrounding the bed)
12. ISO standard rail with restraint grid
13. Mounting panel for controller
14. CPR lever for emergency release of the back rest
15. 150 mm double castors
16. Foot pedal for central brake (
6
), freewheeling ( – )
and fixed direction (
5
) of the double castors
17. Bed linen holder with bracket for staff controller
18. Reinforcement of the HPL panels against kicking through
* Optional special equipment
DESIGN FOR PSYCHIATRIC WARDS
The following differences from the standard equipment are a re-
sult of the special adaptations of the bed to the requirements of
psychiatric treatment:
• Sleeping surface elements not removable (welded)
• Bolted-in, non-removable head / foot boards with sturdily
attached HPL filler boards without gaps between them
and the frame of the head / foot board. (To remove the
head / foot boards, the wall bumpers must be loosened
and removed by means of two screws M8 x 70. After that,
the head / foot board can be pulled up and out.)
• Head / foot boards reinforced with steel rails against kicking
through
*
• Recesses on the head / foot board for retrofitting a full-
length side rail
• No side rails
• Full-length side rail system with snap lock for retrofitting
*
• Removable patient hand controller
*
• Bed linen holder with bracket for controller
• Four firmly bolted wall bumpers
• CPR lever for mechanical back rest release
*
• Stainless steel DIN standard rail, full-length on both
sides for holding accessories and for attaching approved
restraint systems
• Two sockets for accessories at the head and foot end
• Trapeze bar mount (external) at the head end
• Powder-coated metal parts in RAL 9006