Malibu Boats RESPONSE TXi 2021, Owner'S Manual

Page: 87 / 202

2021 OWNER’S MANUAL | Dashes & Video Screens 73
The blue bar will show the
progress through the expected
course.
Press the END GATE button
when crossing the final gate. If
the mapping was unsuccessful,
this screen will appear:
If the remap was successful,
this screen will appear:
Touching CONTINUE will display a keyboard for the user to
name the course that was just mapped.
Auto Detect
Zero Off auto detects previously mapped
courses within a 1 km radius of the boat.
When an auto detected course should be
overridden, simply touch Auto Detect to
turn it off.
Auto detect will be reenabled any time the user changes
modes between slalom, jump, or trick.
Pull Type
Touch the PULL TYPE OFF
(which means it is currently not
operating) to turn this feature
on, and the following screen will
appear:
No two skiers are alike.
Therefore, the pull types exist
to customize the ride to the
skier.
Keep in mind the concepts of Pull and Release. As you begin
your pull, the boat speed begins to drop below the set/target
speed. As you let up on your pull, the boat speed begins to rise
higher than the set/target speed. The letter tells the engine how
quickly to begin to apply or reduce power to get back to the set
speed. The lower the letter (A being the lowest) the longer it will
take for the engine to respond to the speed drop. The higher
the letter (C being the highest) the faster the engine will respond
to the speed drop.
Choose the appropriate type based on the following criteria:
Category A – This provides a slower engine response out of
the buoy, but the boat will tend to move ahead as the skier
approaches the buoy.
Category B – This provides a moderate engine response
compared to A and C.
Category C – This provides a faster engine response out
of the buoy, but the boat will tend to hold back as the skier
approaches the buoy.
The numbers decide how strong the pull of the boat will be
felt by the skier.
Setting 1 – This requires the lowest amount of load before
the system initiates an RPM spread and provides for a softer
pull behind the boat.
Setting 2 – This provides for a moderate pull behind
the boat as compared to 1 and 3.
Setting 3 – This requires the highest amount of load before
the system initiates an RPM spread.
Plus (+) Factor
For each letter setting, the + provides
faster engine response. This will benefit
skiers looking for immediate reaction from
the engine/throttle.
NOTE: The engine will respond quicker
on A+ than on C.
Touch the + Factor to turn On and Off.
Troubleshooting Guide
Display appears not to work or doesn’t come on.
1. Display could be in Sleep mode. Touch a key on the
keypad to activate the display.
2. Check for loose connections at the battery and display
units.
3. Check for reverse polarity on the power connections.
4. Verify the batter has a minimum voltage of six volts.
Display resets or goes off when starting the engine.
1. Check that the display supply wires are connected
properly to the battery.
2. Verify that the battery is charged properly.
3. Check the battery for efficient starter current.
Display has no backlight.
Contact your authorized Malibu dealer for assistance.