Maldol DB-25-M, User Manual

Page: 13 / 32

USER’S MANUAL 9
19.[F] + [1] + [B]: PRI-CH: Priority channel scan setup. Select a priority channel from pre-programmed
CH001-199. Press [F] key to save the setting.
20.[F] + [1] + [9]: SC-REV: Scan-Resume Mode: To: Time scan, the scanner will halt on a signal it
encounters for a while and then resume to scan. CO: Carrier Scan, the scanner will halt on a signal it
encounters and resume to scan after the signal disappear. SE: Search Scam, the scanner will halt on a
signal with matched signaling it encounters resume to scan after it disappear. Press [F] key to save the
setting.
21 .[F] + [2] + [0]: OPTSIG: Optional Signaling Setup. OFF/2 TONE/5 TONE/DTMF selective. Press [F] to
save the setting.
22.{F] + [2] + [1]: SPMUTE: Speaker Mute Setup. QT: Channel with this option will open the speaker
when matched QT/DOT received. AND: Channel will have to check for both QT/DQT and Optional
Signaling in order to open its speaker. OR: Channel will check for either matched QT/DQT or matched
Optional Signaling to open its speaker. Press [F] key to save the setting.
23.[F] + [2] + [2]: PTT-lD: PTT-lD setup: OFF: PTT-lD is disabled. BOT: Press [PTT] to deliver ID code.
EOT: Release [PTT] to deliver ID code.BOTH: Press or Release [PTT] to deliver ID code. (ID code are
PC software pre-programmed, user can select desired ID code in Menu 24 manually). Press [F] to save
the setting.
24.[F] + [2] + [3]: PTT-ID: PTT-IDD transmit delay time setup. Select desired delay time during 0—30
seconds. Press [F] to save the setting.
25.[F] + [2] + [4]: S-INFO: Optional signaling information and auto-dial memory. 1-15 groups optional
signaling encode/decode memories, can be programmed only by PC soltware.