Strona
6
z
26
of temporally delaying the recording of temperature data to the controller's memory
from the moment of its switching on.
7.
Function of saving the maximum temperature value in the washing process.
8.
Function of monitoring and signaling of the measuring sensor damage.
3.3. Programming for the cooling segment.
The controller is factory-programmed for standard operating conditions. In order to
change the factory default, enter the settings mode and make the required corrections.
The following figure illustrates the programming procedure:
3.4. Cooling segment operation by the installer.
Entering the settings can be made both when the cooling process is on or off. In the case
of entering the settings the process is on, the cooling will be interrupted and after
extiting from the settings, the cooling should be switched on again.
3.4.1. Table of settings for the cooling segment.
ATTENTION
The parameters from the table below, which are marked in gray, must not be
changed. The warranty granted by the manufacturer does not cover damage to the
controller due to the change of these parameters.
