5
Misprints and printing errors reserved
PLEASE NOTE! ROTATING PARTS!
AUTOMATIC RESTART!
Take adequate measures to ensure that
all rotating parts are secured against
physical contact whenever the filter is in
operation. Rotating parts may make the
operation of the machine a source of
danger for the service staff.
CAUTION!
Before connecting the filter, make sure it
is not damaged. Carefully check the
power cables and plugs before
connecting them.
Please note:
In case of assembly works, disconnect
all plugs of the device from the power
supply. Also plugs of other equipment
that are in contact with water, must be
removed.
Please note:
Never put your hands in the water before the plug has
been removed from the socket. This applies to all electric
equipment that is immersed or in contact with water.
Please note:
Keep out of reach of children before and during assembly.
Only suitable for people who are aware of the possible
dangers of this device.
Please note:
Never try to stop the drum with your hands when it is
rotating.
Please note:
Ensure that the rinse pump always has sufficient water
during operation. It should not run dry.
Please note:
The drive motor and all electrical connections may not
come in contact with water. If this happens, you must
ensure that everything is thoroughly dry before taking
the filter back into use.
Please note:
The control and rinse pump of this drum filter may only
be connected to an earthed socket. This socket must be
equipped with a 30mA residual current device.
4. USAGE OF THE FILTER
Use the filter only when no body parts are in contact with
the water! Before touching the water you must always
disconnect the filter from the socket.
Compare the electrical specifications on the type plate of
the device with the specification of the connection on the
power supply. Ensure that the device is connected to a
socket with earth and a ground leak switch with a
maximum residual current of 30 mA (DIN VDE 0100T739).
Use the device only when connected to a correctly installed
socket.
Keep the plug and the wiring dry! Ensure that the cables
are protected to prevent damage and consequential short-
circuit.
THE ELECTRICAL WIRING AND/OR PLUGS MAY NOT
BE CUT (THROUGH). DOING THIS WILL CAUSE THE
MANUFACTURER’S WARRANTY TO EXPIRE
IMMEDIATELY.
Only use cables, installations, adapters, extension cables
and connection cables with earthed plugs, that were
approved for outdoor use (DIN VDE 0620) with sufficient
cable diameter. If the wiring is damaged or broken, it
must be replaced. Ensure that the plug will not fall into the
water or get wet. A wet plug must be cleaned by use of
demineralised water and dried. Protect the plug and cables
against heat, oil, UV-light and sharp corners. The
manufacturer is not responsible in any way for any
damage, caused by incorrect installation or as a result of
carelessness of the user or installer.
The cable may not be altered or replaced. Electrical
installations must always comply with the national and
international requirements/guidelines. Never open the
casing of the control electronics. Never make technical
modifications. Use only original parts and accessories, as
set out in this manual. Only authorised dealers are
empowered to perform repairs.
Never use the filter with other liquids than water.
5. Application fields
The Bio-drums or drum filters are suitable for the filtration
of fresh or slightly brackish water.
Temperature water: 4-40 °C.
Ambient temperature: 2 °C to +50 °C
Protection class Electronics: IP54
6. Installation/Connection
Carefully read the manual before installing the filter.
Damage as a result of failing to properly observe the
manual, will not be covered by the warranty.
When unpacking the filter, check whether all parts are
complete and undamaged. Any identified damage must be
reported to your supplier within 24 hours. Check the filter
for damage before you put it into service. Do not use the
filter if it is damaged. If the filter has been used and is
damaged, the warranty and liability will expire.
