Push-to-strike system
Efficiency
All enclosure is made of resin.
Large change lever
For pointing job, you can use
this toolholding barrel
One touch chuck
D-type handle ( Standard accessory)
Bar-handle ( Standard accessorry)
Large model plastic case
(standard accessory)
Automatic cut-off
carbon brush
Large trigger
New torque limitter system
Lamp will light off,when
switch or power supply
cord becomes defective.
Lamp will light up for
indicating time for
replacement of
carbon brushes
Power supply cord or
switch can be easily
replaced.
Speed adjustable dial
*:#Same features as HR4000C
HR5001C
*
*
*
*
*
*
*
*
*
*
Even if the bit touches the electric wire
inside the wall,an electrical shock may
hardly hit on the operator.
The highest efficiency in this class.
Roller clutch system
(#HR4000C:Ball clutch system)
for coping with the higher power,
and for improvement of endurance.
No fatigue at finger after
long operation.
Easy to change opeation mode
between "Hammering only"
and "Rotation with hammerig"
Bit does not jump arround.
Efficiency and endurance
are improved.
without feeling heat from barrel
by resin cover
By just inserting,
the bit can be installed.
Both handles can be fixed at any angle and
at any positions back/forth on the barrel.
The D-type handle for hammering can be
swiveled at 8 positions back/forth.
Holding power required when torque limiter operating
Approx. 20 kgf
Makita #HR5001C
Approx. 29 kgf
Bosch #GBH10DC
600 mm(23-5/8") bit. can be
carried.
270mm
200mm
Carbon brushes can be
replaced without
remove the rear cover.
Longer life motor
The thicness of the commutator is
2 times of HR5000 .
The varnish is coated on the armature
against dust.
Light hammering or drilling
is easily performed
by setting lower speed.
by removing two screws
of handle cover.
It will light up about 8-hr
before the carbon brush are
worn out.
Lit during no defective.