W
iring diagram
P 16/ 16
Terminal
Terminal
Put sag of Connecting lead wire
to Spark plug in this position.
Put lead wires
into lead wire
holders.
Fix lead wires (yellow, black) of
Spark unit with these lead wire
holders without putting sags.
Wind lead wires (red and black) to Line filter one time,
passing them through Line filter. And connect them to
connector of DC Motor.
Flag
receptacle
Straight receptacle
Facing the wire connecting portion to plus mark side,
connect Flag receptacle to Minus terminal.
Line filter
boss
rib
Lead wire to Spark plug has to be pulled
out by 70 up to 75mm from the opening
of Handle set (R).
Put lead wires (black, red)
for DC motor between
Switch unit and boss.
Put lead wire (black) of
Spark plug between rib
and boss.
Switch unit for DC motor
Switch unit for trigger
Connector
Connector to
DC motor
Wire connecting portion
Spark unit
Pay attention not to put
lead wires on the rib in
this area.
Line filter
When putting the following
lead wires into lead wire holders,
do not cross them in this area.
* lead wire (red) to DC motor
* lead wire (black) to DC motor
* lead wire (white) to Switch unit
for DC motor
* lead wire (black) to Switch unit
for DC motor
70 up to 75 mm
Fig. D-2
Wiring in Handle set (R)
Wiring on Cylinder head
Fig. D-3
Pass DC motor’s lead wires (red, black)
through the notch of the rib for setting
DC Motor.
Spark plug
Connector
Put Connector and sag of
lead wires in this position.
Lead wire to Spark plug has to be put
on the other lead wires viewed from
Top cover side.
DC motor
Earth terminal
