12 ENGLISH
Procedure 1
For tool without one-touch type sleeve
►
Fig.12:
1.
Driver bit
2.
Sleeve
To install the driver bit, pull the sleeve in the
direction of the arrow and insert the driver bit into
the sleeve as far as it will go.
Then release the sleeve to secure the driver bit.
For tool with one-touch type sleeve
To install the driver bit, insert the driver bit into the
sleeve as far as it will go.
Procedure 2
In addition to
Procedure 1
, insert the bit-piece into
the sleeve with its pointed end facing in.
►
Fig.13:
1.
Driver bit
2.
Bit-piece
3.
Sleeve
To remove the driver bit, pull the sleeve in the
direction of the arrow and pull the driver bit out.
NOTE:
If the driver bit is not inserted deep
enough into the sleeve, the sleeve will not return
to its original position and the driver bit will not be
secured. In this case, try re-inserting the bit
according to the instructions above.
NOTE:
When
it
is
difficult
to
insert
the
driver
bit,
pull
the
sleeve and insert it into the sleeve as far as it will
go.
NOTE:
After
inserting
the
driver
bit,
make
sure
that
it
is
firmly
secured.
If
it
comes
out,
do
not
use
it.
Installing hook
►
Fig.14:
1.
Groove
2.
Hook
3.
Screw
The hook is convenient for temporarily hanging the
tool. This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a
screw. To remove, loosen the screw and then take
it out.
OPERATION
►
Fig.15
The proper fastening torque may differ depending
upon the kind
or
size
of
the
screw/bolt, the
material
of
the
workpiece to be fastened, etc. The
relation between fastening
torque
and
fastening time
is
shown
in
the
figures.
Proper fastening torque for standard bolt
1.
Fastening time (second)
2.
Fastening torque
Proper fastening torque for high tensile bolt
1.
Fastening time (second)
2.
Fastening torque
Hold
the
tool
firmly
and
place
the
point
of
the
driver
bit
in
the
screw
head.
Apply
forward
pressure to
the
tool
to
the extent that the bit
will not slip off the screw and turn the tool on to start
operation.
NOTICE:
If you use a spare battery to continue
the operation, rest the tool at least 15 min.
NOTE:
Use
the
proper
bit
for
the
head
of
the
screw/ bolt that you wish to use.
NOTE:
When
fastening M8
or
smaller
screw,
carefully
adjust
N•
m
(
kgf•cm
)
M14
M12
M10
M8
M16
M14
M12
M10
M8
M16
140
(1428)
(1224)
(1020)
(816)
(612)
(408)
(204)
120
100
80
60
40
20
0
1
2
1
2
2
1
M14
M12
M14
M12
M10
M8
M10
M8
200
180
160
140
120
100
80
60
40
20
3
2
1
0
(2040)
(1836)
(1632)
(1428)
(1224)
(1020)
(816)
(612)
(408)
(204)
N•
m
)
(
kgf•cm
