12
Disconnecting your Bluetooth
®
device
Press and hold the Pair button
for 2-3 seconds to
disconnect with your Bluetooth
®
device. “BLUETOOTH”
will disappear from the display indicating deactivation of
Bluetooth
®
.
Charging with USB power supply port
(Fig. 10)
There is the USB port at the front side of the radio. You
can charge USB device trough the USB port.
1.
Connect the USB device, such as iPod, MP3, or CD
player, with USB cable available in the market.
2.
Press the Power button
to switch on your radio.
3.
No matter if the radio is AC powered or battery
powered, the radio can charge the USB device when
the radio is switched on and in FM radio mode, or BT
mode, or AUX mode, which is appeared when an
external audio source is connected.
Note:
You cannot charge USB devices during AM mode
because radio signal reception becomes extremely poor
when charging USB device.
• The maximum volume of the output power speaker will
decrease when your USB is charging.
• The USB socket can provide max 1A5V of electrical
current.
Important:
• Before connecting USB device to the charger, always
backup your data of USB device. Otherwise your data
may lose by any possibility.
• The charger may not supply power to some USB
devices.
• When not using or after charging, remove the USB
cable and close the cover.
• Do not connect power source to USB port. Otherwise
there is risk of fire. The USB port is only intended for
charging lower voltage device. Always place the cover
onto the USB port when not charging the lower voltage
device.
• Do not insert a nail, wire, etc. into USB power supply
port. Otherwise a circuit short may cause smoke and
fire.
• Do not connect this USB socket with your PC USB
port, as it is highly possible that it may cause
breakdown of the units.
MAINTENANCE
CAUTION:
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Specifications:
Power Requirements
AC power adaptor
DC12 V/1,200 mA, center pin
positive
Battery
UM-3 (AA size) x 2 for back up
Cluster battery: 7.2 V - 10.8 V
Slide battery: 10.8 V - 18 V
Frequency coverage
FM 87.50 - 108 MHz
(0.05 MHz/step)
AM (MW) 522 - 1,710 kHz
(9 kHz/step)
Bluetooth
®
Bluetooth
®
QD ID
58625
(The Bluetooth
®
word mark and
logos are registered trademarks
owned by Bluetooth SIG, Inc.)
Bluetooth
®
version
4.0
Bluetooth
®
profiles
A2DP/SCMS-T
Transmission power
Bluetooth
®
specification power
Class 2
Transmission range
Max. 10 m (varies according to
usage conditions)
Supported codec
SBC
Compatible Bluetooth
®
profile
A2DP
Circuit feature
Loudspeaker
3.5 inches 8 ohm x 2
Output Power
7.2 V: 0.5 W x 2
10.8 V:1.2 W x 2
14.4 V: 2.2 W x 2,
18 V: 3.5 W x 2
Input terminal
3.5 mm dia. (AUX IN1/AUX IN2)
Antenna system
FM: soft bended rod antenna
AM: bar antenna
Dimension (W x H x D) in mm
282 x 294 x 163
