4
ENGLISH
Explanation of general view
SPECIFICATIONS
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING:
When using electric tools, basic safety precautions should
always be followed to reduce the risk of fire, electric
shock, and personal injury, including the following:
READ ALL INSTRUCTIONS.
1. Read this instruction manual and the charger
instruction manual carefully before use.
2. This Job site light is not waterproof. Do not use it in
damp or wet locations. Do not expose it to rain or
snow. Do not wash it in water.
3. A short-circuit can cause a large current flow,
overheating, possible burns and even a breakdown.
(1) Do not touch the inside of the Job site light with
tweezers, metal tools, etc.
(2) Do not touch the battery terminals with any
conductive material.
(3) Avoid storing the battery cartridge in a container
with any metal objects such as nails, coins, etc.
4. Never expose the battery cartridge to flames, fire or
great heat. Breakage may cause release of injurious
material.
5. If electrolyte gets into your eyes, rinse them out with
clear water and seek medical attention right away. It
may result in loss of your eyesight.
6. If operating time has become excessively shorter, stop
operating immediately. It may result in a risk of
overheating, possible burns and even an explosion.
7. Be careful not to drop, shake or strike battery.
8. When the tool is not in use, always switch off and
remove the battery cartridge from the tool.
9. Do not store the tool and battery cartridge in locations
where the temperature may reach or exceed 50°C
(122°F).
10. Do not give the tool a shock by dropping, striking, etc.
11. Do not expose the light to eyes continuously. It may
hurt them.
12. Do not cover or clog the lit tool with cloth or carton,
etc. It may create a risk of fire.
13. Switch off the light immediately when the lamp gets
dark in use. If you leave the lamp switched on, the
battery cartridge capacity may decrease.
14. Do not disassemble the charger or battery cartridge;
take it to a qualified serviceman when service or repair
is required. Incorrect reassembly may result in a risk
of electric shock or fire.
15. If any problem develops, consult your nearest Makita
Service Center or dealer. To maintain product safety
and reliability, repairs, maintenance or adjustment
should be carried out by Makita Authorized Service
Center.
16. If you notice that the tool is hot or in abnormal
condition, consult your near-est Makita Service Center
or dealer. When the switch is turned “ON”, the handle
of the tool may become slightly hot, even if the
fluorescent tube is not installed or is not lighted. This
is a normal condition and does not indicate problem.
SAVE THESE INSTRUCTIONS.
1.
Battery cartridge
2.
Button
3.
Red part
4.
Fluorescent tube
5.
Lamp cover
6.
Screw ring
7. Switch
8. Hook
9. Strap
10. Loosen
11. Tighten
12. Cap
13. Head cover
14. Bulb holder
15. Bulb
16. Ring
17. Metal fitting
18. Metal hook
Model
BML184
Power source
D.C. 18 V/14.4 V
Fluorescent tube
Compact FL13 W
Bulb
18 V 0.2 A
Dimensions
Hook is lengthened
L
450 mm
W
95 mm
H
78 mm
Hook is compressed
L
370 mm
W
95 mm
H
78 mm
Net weight
0.4 kg
