R
epair P 9 / 14
<10 > Assembling parts in gear housing
Fig.21
Fig.22
Fig.23
1. Assemble flat washer 8 to the shaft in gear housing. See Fig. 21.
4. Assemble gear complete and balance plate to the shaft in gear housing. See Fig. 23.
5. Assemble crank complete to gear housing. With turning crank complete, press it down to the position in which
you can see the shaft's groove for retaining ring S-8. See Fig. 24.
6. Lock crank complete with something like 1R235 "round bar for arbor", and fasten crank complete
with 2 pcs. of hex socket head bolts M4 x 12 with adhesive. See Fig. 25.
7. Assemble retaining ring S-8 to the shaft of gear housing. See Fig. 26.
2. After assembling seal plate to push plate, assemble them to the shaft in gear housing. See Fig. 22.
3. Lubricate the parts with referring to " < 1 > Lubrication " at page 2.
< Note >
Do not fasten with the used hex socket head bolts M4 x 12. The fresh adhesive hex socket head bolts M4 x 12
have to be used. The fastening torque of these bolts is 2.4 - 3.5 N.m.
Gear housing
Flat washer 8
Gear housing
Push plate
Seal plate
Gear complete
Balance plate
Fig. 24
Fig. 25
Press crank complete down to the position where
you can see the shaft's groove for retaining ring S-8.
Crank complete
2 pcs. of hex socket
head bolts M4 x 12
Crank complete
Balance plate
Retaining ring S-8
Something like
1R235 "round bar for arbor"
Fig. 26
Retaining ring S-8
Flat washer 8
Push plate
Seal plate
Balance plate
Gear complete
Crank complete
Gear housing
Groove for retaining ring S-8
