R
epair P 7 / 14
< 7 > Disassembling blade holder
< 8 > Assembling blade holder
1. Disassemble rod with referring to "< 5 > Disassembling gear housing cover section" at page 4.
1. Apply MAKITA grease FA No.2 to push pin and set it in the hole of rod. And assemble torsion spring 15 to rod by
inserting its tail shown in Fig. 13 into the hole of rod.
2. Set blade holder to rod as illustrated in Fig. 14. And bring the tail of torsion spring 15 to the space A of blade
holder as illustrated in Fig. 15.
3. Push rod into blade holder, and assemble retaining ring R-18 to the groove in blade holder as illustrated in Fig. 16.
4. Assemble dust cover as illustrated in Fig.17.
2. Disassemble dust cover, and then disassemble retaining ring R-18. as illustrated in Fig. 12.
So, blade holder and torsion spring 15 can be separated from rod as illustrated in Fig. 12A.
Dust cover
Retaining
ring R-18
Rod
Blade holder
Blade holder
Torsion spring 15
Be careful, not to lose push pin,
when disassembling.
Fig. 12
Fig. 12A
Insert this tail into
the hole of rod.
Fig. 13
Push pin
Torsion spring 15
Rod
Aligning the mark
of blade holder and
push pin, set blade holder
to rod.
Blade holder
Fig. 14
Fig. 15
Bring this tail to the
space A of blade
holder by turning
clockwise.
Space A
Retaining ring R-18
Dust cover
Fig.17
Fig. 16
Press dust cover to assemble
firmly to blade holder.
