Makerfarm Pegasus 12, Instructions Manual, Page: 78 / 80

78
Using Pronterface
Now that you have everything installed you will open pronterface
select the com port that your printer installed to and set the
speed to 250000 then click connect.
Next set your Speeds:
Now you are going to test our endstops and make sure the
motors are plugged in correctly. First
click the button,
your heat
bed should move forward and hit the switch causing the heat bed
to stop.
If your heat bed moves to the back of the printer instead you can
turn the power supply off, unplug your usb cable and flip the
connector around 180 degrees for the Y motor.
Once the Bed moves the correct direction you can adjust the Y
endstop until the nozzle is just behind the back edge of the
Glass. For the X adjust it so the nozzle doesn‘t hit the bolt
holding the bed to the printer. For the Z endstop there will be an
M3 bolt that will contact the switch, you can turn the bolt
clockwise and counter clockwise until
the correct
home position has been reached which will be just
barely touching the glass.
Then repeat for the other axis using the buttons.