Makerfarm Pegasus 12, Instructions Manual, Page: 74 / 80

74
Manual Bed Leveling
The Firmware used on the Pegasus printer has a “Manual Bed Leveling” Feature, basically
you tell the printer when the nozzle touches the glass in 9 different spots then in future prints
the firmware will raise and lower the nozzle while printing to accomidate for an uneven or
unlevel surface. Now that you have your endstops set you setup the Manual bed leveling
feature.
Start at the main LCD screen, push the knob and turn the rotary knob to select “Prepare”
then push the knob again.
Then turn the knob until the arrow points at “Level Bed” then push the knob. The printer
will home then the nozzle will move to the position shown below. Turn the knob until the
nozzle just barely touches the glass then push the knob. The printer will then move to 8
other locations, turn the knob to move the nozzle up or down then when it just barely
touches the glass push the knob again.
Once complete go back and select the “Control” menu, then “Store Memory”