Major Science Winpact SI-200, User Manual, Page: 43 / 97

43
Switch to “
step ” column to set up all the parameters in each step. Select the step by
pressing and . Push and then to set up the running time.
*
5
Use
and to adjust the numbers; then press or to move from the hour
and the minute parameter. After finishing the time setting, push to confirm the
adjustment. Then use to move on to the rest parameters. Press to start
setting up and press again to confirm the adjustment.
*Note (3):
The program will run the loops in sequence from Loop1 (Step1-Step3) to Loop9
(Step1-Step3).
*Note (4):
If user doesn’t need all the loops in the program, set the cycle at 0 in the next loop. For
example, only 3 loops are needed in the program; then just set 0 in the column of cycle in
Loop4, the system will automatically ignore the rest settings of loops. But each program
should contain at least 1 loop. In that, the cycle of
the first loop in every program is
restricted to the range from 1 to 999 times. And the cycle of the rest loops is from 0 to
999.
*Note (5):
If user only needs 1 step or 2 steps in a loop, set 0 : 00 in the time column. The system will
ignore the rest of steps in the same loop. For instance, the time is set at 0 : 00 in Loop1,
Step2; then the program will run Loop1, Step1, and skip the rest steps in Loop1, and
directly proceed to Loop2.