37
Majestic • JADE32IN, JADE42IN, JADE42IL Installation Manual • 2491-986 Rev. K
• 10/18
WARNING! Risk of Fire!
DO NOT remove factory-
installed non-combustible material.
D. Non-Combustible Material Installation
INSTALL TWO OF THE
PROVIDED SCREWS INTO
THESE PILOT HOLES
INSTALL FOUR
OF THE PROVIDED
SCREWS INTO
THESE PILOT HOLES
NOTE: BOTH LEFT &
RIGHT SIDES
Figure 6.6 Shipping Position - Non-Combustible Sides
SPLATTER GUARD
This model ships with the required top, left and right non-
combustible board. The top non-combustible board has
been pre-installed at the factory with three screws. The
left and right side non-combustible boards are shipped in
the cardboard splatter guard in front of the appliance. See
Figure 6.6.
1. Remove the left and right non-combustible components
from the shipping position and set aside.
2. Remove the lower cover panel by removing two screws
located on the lower left and right sides of the appliance
opening. Retain screws. Lift the lower cover panel “up”
and “out” to remove.
3. Locate the manual bag assembly and remove the small
package containing the 1-1/2 inch Phillips screws.
Note:
Care should be taken when installing screws into
the non-combustible board. DO NOT overtighten screws.
Screws should be set “flush” to the surface of the non-
combustible board.
4. Further secure the top non-combustible board by
installing screws into the pilot holes located in the upper
left and right corners of the top non-combustible board
as shown in Figure 6.7.
5. Install the left and right non-combustible components
with four of the provided Phillips screws. See Figure
6.7.
6. Install drywall screws (not provided) around the
perimeter of the installed non-combustible components
to secure it to the framing material. Refer to Section
10 for more information.
Figure 6.7 Installation of the Side Non-Combustible Components
