DVB Series Direct Vent Gas Fireplace
48
54D0701
FINAl INstAllAtIoN
RocK Wool plAceMeNt
1. Place rock wool on burner to provide glowing embers.
For best results, pull the rock wool apart into pieces
the size of a dime or smaller.
2. Distribute one layer of rock wool to cover the burner.
Figure 60
3. Place the logs on the burner. Refer to
Log Placement
below. Light unit and after 15 minutes, check burner
flame and glow. Refer to
Burner Flame
, Page 49.
If the flame is blue and only in the center, turn off unit
and let cool. After unit cools, remove logs. If the back
holes are clear, add more rock wool to the center of the
burner. Replace logs and check flame again. Save left
over rock wool to refresh when cleaning later. Too much
rock wool can disturb the flame and cause sooting on
the glass or logs.
FP2105
BDV base
Figure 60 - Placement of
Rock Wool on Burner
Cover with
Rock Wool
Burner
FP2105
W
ARNING
Do not use the entire bag of rock wool to
cover the burner. this could cause the flame
to burn poorly and may lead to sooting.
loG plAceMeNt
1. Place rear log (#1) on grate assembly. Log should
rest firmly on the two log mounting pins on the
bars.
Figure 61
2. Place bottom left log (#2) on grate. Rest the back
side of the log in the flat area of the rear log.
Figure
61
3. Place bottom right log (#3) on grate. Rest the
back side of the log in the flat area of the rear log.
Figure 61
4. Place the top log (#4) on the rear log. Nest the
forked end of the top left log into the fork or the
rear log. Rest the narrow end of the top on the
vertical grate bar.
Figure 61
lAVA RocK AND eMBeRs plAceMeNt
Sprinkle lava rock on the floor of the inner combustion
chamber. Evenly distribute the rock. Do not pile the lava
rock up in front of grate. Do not place lava rock on the
burner. If desired, purchase optional embers to decorate
the floor of the fireplace.
LG607
DVB logs
Top Log #4
Bottom Left
Log #2
Bottom
Right
Log #3
Log Mouting
Pins
Flat Areas
Rear Log
#1
Left Verti-
cal Grate
Bar
Center Vertical
Grate Bar
Right Vertical
Grate Bar
LG607
Figure 61 -
Log Placement
(300DVB & 400DVB Shown)
W
ARNING
Do not sprinkle the lava rock or ember
chunks on top of the burner. this may cause
potential sooting, glass breakage and a fire
hazard