MIEN5208 Series Managed Industrial Ethernet Switch
- 15 -
equipment do not support flow control
Extreme line transform:
MDI
（
Medium Dependent Interface
）
, MDIX( “X”
cross line ), that is the way Ethernet port connect to router, HUB , Ethernet
switch . That series just use Auto-MDI/MDIX,have
auto –turn over function, that choice user can not change .
For a detailed description of port configuration, see below table:
Statement:
The MIEN5208 series managed industrial Ethernet switches provide
web page function configuration. All configuration parameters will be
submitted to the switch after clicking the configuration button. Before exiting
this page, any changes made by the user will be canceled. Clicking the
Cancel button will not submit the changes made by the user and restore the
page to what it was before the modification.
The pages mentioned below are basically the same, that is, the settings
are saved after clicking Configure.
After clicking the configuration button, the web page first jumps to the
waiting interface, and the progress bar in the interface prompts the progress
of the configuration. When the configuration is completed, the web page
automatically jumps back to the previously configured function page. If the
configuration is successful, the values of the parameters in the page at this
time are the previously configured parameter values.
During the configuration process, the switch cannot be powered off or
perform other operations. Otherwise, the configuration will fail.
Setting item
Description
Defaults
Port type
Media interface type, Copper
or fiber port
Free factory setting
Rate mode
Port transfer rate
Auto-negotiation
Duplex mode
Port transfer mode
Full duplex
Port enable
Enable or disable ports
Enable
flow control
Data transfer management
between two network nodes
Not enabled
Extreme line
transform
Media interface wiring type
Automatic flip
