MyPower S6600 Series Routing Switch Installation Manual
Installation Preparations
copyright
©
2015 Maipu All rights reserved.
1
F
F
F
F Wiring
Wiring
Wiring
Wiring Recommendation
Recommendation
Recommendation
Recommendation
F1
F1
F1
F1
Wiring
Wiring
Wiring
Wiring Recommendation
Recommendation
Recommendation
Recommendation during
during
during
during Installation
Installation
Installation
Installation
When wiring for the S6600 series routing switch, laying from left or right as
required and go through the cabling rack on both sides. The cable laying mode is
shown in the following figure.
A
A
A
A
P P E N D I X
P P E N D I X
P P E N D I X
P P E N D I X F I G U R E
F I G U R E
F I G U R E
F I G U R E
F
F
F
F
1
1
1
1 T
T
T
T
H E
H E
H E
H E D I A G R A M
D I A G R A M
D I A G R A M
D I A G R A M O F
O F
O F
O F T H E
T H E
T H E
T H E
S 6 6 0 0
S 6 6 0 0
S 6 6 0 0
S 6 6 0 0
S E R I E S
S E R I E S
S E R I E S
S E R I E S R O U T I N G
R O U T I N G
R O U T I N G
R O U T I N G S W I T C H
S W I T C H
S W I T C H
S W I T C H C A B L E
C A B L E
C A B L E
C A B L E
L A Y I N G
L A Y I N G
L A Y I N G
L A Y I N G
The wiring principle is separate wiring of the interface cable and power cable.
Through reasonable wiring, it can be convenient to remove or install the switch
fan module and power module parts and increase the efficiency.
�
The interface cable is bound to the both sides of the cabinet by the cabling rack
in front of the chassis. Arrange the cable layout from top or bottom according
to the equipment room condition (the signal wire in the equipment room is
connected from the cabling rack on the top of the cabinet or the cabling
channel on the ground).
�
Place all connected data signal cable connector on the bottom of the cabinet.
Do not put it outside the cabinet where are easy to be touched.
�
The power cable is wired from the rear end of the cabinet. Arrange the wiring
from top or from bottom according to the equipment room condition (power
distribution cabinet, and terminal strip).
