26
Mainstreet Equipment
User Manual
FAULT
POSSIBLE CAUSE
SOLUTION
Machine stops during operation.
Electrical installation overloaded.
Call technical service to modify electrical
installation.
Machine protection has tripped.
Reset safety device and if it trips again, call
technical service.
Machine stops and fills with water when
it is washing.
Pressure switch pipe blocked.
Empty the tub and clean thoroughly.
Pressure switch faulty.
Call the technical service to replace it.
Overflow incorrectly mounting.
Mount overflow correctly.
The machine does not start with the
wash cycle.
Hood/door is not closed properly.
Close the hood/door correctly and if it is seen to
re-open alone, call the technical services to adjust
the tensioners.
Hood/door micro switch faulty.
Call the technical service to replace it.
Machine does not drain completely.
Machine not leveled correctly.
Level the machine. In the event of doubt, please
contact your technical service.
Pressure switch faulty.
Call the technical service to replace the pressure
switch.
NOTE: If a fault occurs and is not listed in the above table, please call the
technical service. The manufacturer reserves the right to modify the tech-
nical characteristics with prior warning.