12
Mainstreet Equipment
User Manual
8.3 Electrical connection
An AUTHORIZED TECHNICIAN should always carry out the appliance’s
electrical connection.
The dishwasher shall be installed in accordance with local codes, or in the absence of local codes,
installed in accordance with the applicable requirements in the National Electrical Code, NFPA 70,
Canadian Electrical Code (CEC), Part 1, CSA C22.1, and Standard for Ventilation Control and Fire
Protection of Commercial Cooking Operations, NFPA 96.”.
THIS APPLIANCE, WHEN INSTALLED, MUST BE ELECTRICALLY GROUNDED
The manufacturer cannot accept any responsibility for damage caused from a failure to observe
grounding instructions.
• Refer to the wiring diagram, the machine data plate and technical specifications for service size
requirements.
• Check that the mains voltage corresponds to that indicated on the nameplate.
• The power-supply cord shall be Type S, SE, SO, SOO, ST, STO, or STOO (with or without W at the
end).
• The power supply cord wire size must be suitable for the rated current of the machine (amperage
load). Use copper conductors only.
• The appliance must be grounded using the ground connection of the terminal block of the
appliance.
• An all phase Circuit Breaker must be installed near to the appliance between the power supply
and the appliance in accordance to required consumption guidelines. Switch the circuit breaker to
“OFF” when servicing the appliance. It is recommended that it has lockout-tagout capabilities. The
manufacturer will not be held liable for damage originated by failure to observe this requirement.
• A suitable safety switch / Residual current device must be installed near the appliance between the
power supply and the appliance. The manufacturer will not be held liable for damage originated
by failure to observe this requirement.
• If any faults are observed during the installation, the supplier should be notified immediately.
When a number of appliances are installed in line, they should all be ground bonded at the point provided for
that purpose.
To access the connection strip when a permanent connection needs to be made, release the cover of the
machine’s front (see Section 2 - General Measurements and Connections). The power cable is connected to the
connection strip. It is also possible to change the machine configuration here.
The manufacturer will not be held liable for any personal or material damage to the machine
resulting from incorrect installation or failure to comply with the manufacturer’s specifications.
It is the personal responsibility and obligation of the customer to contact a qualified electrician
to assure that the electrical installation is adequate.