Step 2.
Install UV-C bulbs and purifier
Install UV-C bulbs
1.
Two replaceable UV-C bulbs are shipped with this unit. Carefully
remove bulbs from their packaging.
2.
Insert one bulb into each of the two bulb sockets located behind the
front facing plate.
Handle carefully, from the bulb base, and avoid touching the glass.
3.
Slide the socket end of each bulb, through the oval opening in the back
plate. Align and insert bulb socket pins with the socket pin holes at the
front plate of the unit.
4.
Apply firm gentle pressure to ensure full socket connection.
Snap the bulb into the clear bulb retainer clip.
Install Purifier
1.
This unit ships with one replaceable activated carbon/potassium
permanganate purifier (AC/PP).
Locate the purifier and remove from its protective package.
2.
Remove six screws to permit AC/PP access plate removal, exposing the
purifier opening and track.
3.
Insert the AC/PP purifier into the track and slide all the way to the back
of the unit. (There is no preferred flow direction for the purifier)
4.
Replace the AC/PP access plate and six screws.
NOTE:
Purifier is packaged separately to prevent
exposure and damage during shipping.
Step 3.
Determine the Mounting Location
Ensure the ductwork in the mounting location is
deep-enough to accommodate the length of the unit.
The Qwik
Pure
TripleGuard
™ purifier can be mounted horizontally, vertically, or at any angle
in-between.
Do not install upside down, air flow must pass thru the AC/PP purifier last.
Maximum performance is achieved when the Qwik
Pure
TripleGuard
™ is located in the
air plenum just after (downstream of) the air handling unit. This is the supply or post-
evaporator air side of the air handler, not the return air side. This unit does not replace
the traditional air filter located on the return side of the air handler whose purpose is to
filter out particulate matter and dust.
Because you will be cutting into the supply duct, we recommend mounting Qwik
Pure
TripleGuard
™ Air Purifier in the supply duct, not the sheet metal of the air handler to
avoid any potential damage to components inside the air handler. When considering a
mounting location, consider the power source location—typically the power source is
the air handler itself.
The Qwik
Pure
TripleGuard
™ Air Purifier can operate on any AC voltage between 120
and 240 volts. Typically, residential AC air handlers and heat pumps operate on 240 Volts
AC and furnaces operate on 120 VAC.
The electrical connection should be performed
by a licensed electrician.
Fuses are suppled to provide over-current protection.
When considering a mounting location, remember the AC/PP oxidizing purifier is to
be changed annually, so ensure there is ample space to slide the purifier out of the
Qwik
Pure
TripleGuard
™ without any obstructions limiting the travel.
CLEAR
BULB RETAINER CLIP
