Supplied By www.heating spares.co Tel. 0161 620 6677
11
Part No. 5000893
Installation
Fig. 11
3. Installation
3.1
Location
1. If the appliance is to be fixed to a suitable
existing terminal first isolate and remove
the old appliance. Leave the flue terminal
in place. Retain the fixing nuts and
washers. Make good any damage to the
brickwork or plaster around the terminal.
Cut off the existing pipework at a
convenient point below the appliance.
Important:
Refer to the template
supplied with the flue for the positions of
the new water inlet, water outlet and gas
pipes.
2. If installing a new flue terminal, guidance
is given on the template sheet supplied
with the terminal pack.
Note:
Where the appliance is to be
installed into a SEDUCT the minimum
duct required is 228mm (9in) deep,
349mm (15
fi
in) wide.
3. Where the building regulations require it,
a flue terminal guard should be fitted
symmetrically around the outer part of
the flue terminal.
4. Unpack the water heater. Find the bags
of accessories before discarding the
packaging.
5. Slide off the bottom cover then remove
the three screws securing the outer case
and carefully lift it off.
6. Use the self adhesive discs supplied to
cover the unwanted fixing holes in the
back of the new appliance as shown.
Fig. 9
Fig. 10
