21. Remove:
A. Kick starter
1. 360-250 - Remove snap ring
and loosen pinch bolt -
ice pick and l7mm wrench.
2. 400-501 - Remove 6mm bolt
10mm wrench.
B. Remove seven 6mm screws from
the cover - medium blade
screw driver.
C. Pull the cover straight up
Note: For serv1c1ng clutch with en-
gine in the frame, lay the
machine over with the right
side down. Pull the plastic
.transmission vent hose out of
the case just above the chain.
Turn the hose
180
0
so that
transmission oil will not run
out. Having the motorcycle
level will greatly assist
when replacing the clutch springs.
22. Remove the clutch snap rings
with special puller and two
small blade screw drivers.
www.maicowerk.com
Courtesy of [email protected]
Square Barrel Engine Manual Service Manual
