37. Remove spring from hook rachet -
needle nose pliers.
38.
Remove left hand case - by hand
and.rawhide hammer.
39. Remove crank shaft assembly -
by hand.
40. Check flywheel alignment by ro-
tating on knife edges. Max. mis-
alignment is .002 inch at the end
of the magneto shaft, re-align
if
necessary. This must be done by
a motorcycle shop or a machine shop.
NOTE. It is suggested to reassemble the flywheels using
Loctite grade
35
and Loctite primer grade T. To
disassemble loctited flywheels heat to 450-500
0
F
in an~.
Do not use a torch.
37. Remove spring from hook rachet -
needle nose pliers.
38.
Remove left hand case - by hand
and.rawhide hammer.
39. Remove crank shaft assembly -
by hand.
40. Check flywheel alignment by ro-
tating on knife edges. Max. mis-
alignment is .002 inch at the end
of the magneto shaft, re-align
if
necessary. This must be done by
a motorcycle shop or a machine shop.
NOTE. It is suggested to reassemble the flywheels using
Loctite grade
35
and Loctite primer grade T. To
disassemble loctited flywheels heat to 450-500
0
F
in an~.
Do not use a torch.
www.maicowerk.com
Courtesy of [email protected]
Square Barrel Engine Manual Service Manual
